Difference between revisions of "HDMI display does not display after installing FBCP driver"
(Created page with " ==<font color="blue">Phenomenon</font> == For the following products: RPi MHS - 3.5 inch Display MHS - 4.0 inch Display - B Following the steps of the wiki page to...") |
|||
| Line 1: | Line 1: | ||
| − | + | {{lan | |
| + | | | ||
| + | cn=http://www.lcdwiki.com/zh/安装支持FBCP的驱动后HDMI显示器无显示 | ||
| + | | | ||
| + | en=http://www.lcdwiki.com/HDMI_display_does_not_display_after_installing_FBCP_driver | ||
| + | }} | ||
==<font color="blue">Phenomenon</font> == | ==<font color="blue">Phenomenon</font> == | ||
For the following products: | For the following products: | ||
Revision as of 21:06, 17 May 2019
Phenomenon
For the following products:
Following the steps of the wiki page to install the driver supporting FPCP, the above display can display normally.
However, the hdmi-connected monitor displays nothing or is prompted "input not supported", etc
analysis
Since the default output resolution of the driver installed in the above products is 480*320, and many traditional HDMI displays do not support HDMI input signal lower than 800*600, the HDMI display cannot display normally or even without display.
solution
Open the config. TXT file in the TF root directory,
Find hdmi_cvt 480 320 60 60 0 0 0 lines At the end of the file,
Change the value of 480 320 to the corresponding value of resolution above 800*600 (note the space),
Example: change to 1024*600 resolution
Hdmi_cvt 1024 600 600 60 600 00
Save and safely pop up TF, insert raspberry pie and restart.
